•┈┈••✦✿✦•❤️•✦✿✦••┈┈•

▼

Thursday, October 15, 2020

Electrical Safety

 1) Do not work on live circuits; if unavoidable,....

- Use rubber gloves rubber mats,etc

2) Which one of the use handle screw drivers  when working on electrical circuits?

- Wooden or PVC insulated

3) Use only correct capacity fuses in the circuit.

- If the capacity is less it will blow out when other load is connected

4) Replace or remove fuses only after switching...

- Off the circuit switches

5) Use extension cords with lamp guards to protect lamps..

- Against breakage and avoid

6) Which correct accessories are use like sockets , plugs and switches and appliances..

- If they are in good condition and be sure they have the mark of BIS (ISI)

7) Never extend Electrical Circuits by..

- Using temporary wiring.

8) Which equipments are use while working on poles and high rise points?

- Safety belts.

9) Run Cables or cords through wooden partitions or floor after  inserting...

- Insulating porcelain tubes.

10) Connections in the Electrical apparatus should be tight.

- Loosely connected Cables will heat and end in fire hazard.

- Loosely connected switches will heat and end in fire hazard.

- Loosely connected MCB will heat and end in fire losses.

11) Use always earth connection for all Electrical appliances along with...

- Any pin sockets and plugs.

12) While working on dead circuits remove the fuse grips; keep them under...

- Safe custody and also display Men on line board on the switchboard 

13) Do not connect earthing to the ....

- Water pipe lines

14) Do not use water on ....

- Electrical equipment.

15) Standardization can be defined as the process of formulating and applying...

-  Rules for an orderly approach to specific activity

16) For various goods through their booklets, the standard is specified by.....

- Bureau of Indian standard BIS (ISI)

17) There are a number of organization for standardization throughout....

- The world in different countries.

18) Which country is operated GOST the organization for standardization?

- Russia

19) Advantages of BIS (ISI) certification marks scheme to manufacturers.

- Streamlining of production processes and introduction of quality control system.

- Indipendent audit of quality control system by BIS.

- Reaping of production economics accruing from standardization.

20) However, if you are not sure about the area of control of sub- main switches,.....

- It is always better to switch off, the main switch itself.

21) Educate the inmates of the house how to...

- Switch off the circuit in case of any emery.

22) Generally accidents do not happen; they are caused....

- Most accidents are avoidable.

23) Safety in a workshop can be broadly classified...

- General safety.

- Person safety.

- Machine safety.

24) Keep the floor and gangways clean and clear.....

- General safety.

25) Move with care in teh workshop, do not run.

- General safety.

26) Don't touch or handle any equipment machine unless authorised to do so.

- General safety.

27) Don't leave the machine which is in motion.

- General safety.

28) Keep the overall buttons fastned.

- Personal safety.

29) Kinds of road signs.

- Mandatory,

- Cautionary and,

- Informatory.

30) Never start a machine unless .....

- All the safety gards are in position.



No comments:

Post a Comment